CABRIOLE’
CRAMARO TS S.r.l. – 37044 COLOGNA V.TA (VR) - VIA QUARI DESTRA, 71/G TEL. +39 0442/411688 / FAX + 39 0442/411690
E-MAIL [email protected] WEBSITE: http://www.cramaro.com -
Manual n° MCA016-EN-ED00 – date 15/01/15
page
23
FIG 27
FIG 28
FIG 29
430
MAX
CLOSURE WITH SPRING TAIL
Used mainly for containers that have
a HYDRAULIC-activated rear door and, as such,
have a part of the sideboards that lift up
along with the rear door
In these cases, the tarpaulin cannot reach far enough back
to completely cover the container
and, therefore, the TAIL WITH SPRING can be used
Some steel
FLAT SPRINGS
inserted in an internal pocket
of the sheet allow it to roll up and uncover the opening.
Once the container has been covered, extract the rear
section of the
tarpaulin (the part on the rear unloading door) and
hook the rear elastic tie rods to the specific hooks
(cobra) secured to the container
CLOSURE WITH AUTOMATIC FLAP
This type of REAR CLOSURE uses and AUTOMATIC lifting system to lift the last section of the sheet. The LIFT -
LOWER movement is directly activated by moving the last tarpaulin bow
There can be TWO different types of FLAPS
- DOUBLE BOW FLAP -
Made with two bows that are distanced and welded
to each other, it
guarantees good sliding stability and can
cover an empty space between the last bow and the door equal to
about 410mm.
In
OPENING,
the action of
two TRACTION SPRINGS
positioned on the sides of the last bow allows the section
of the sheet covering the door to be lifted immediately. In
CLOSURE,
instead, the action of two
small CHAINS
anchored on one side
to the side arms of the flap
itself
and, on the other,
to the next to last tarpaulin
bow
allows the arms to lower just as quickly and,
therefore, the
section of the sheet covering the door to be closed.
- SINGLE BOW FLAP -
Made with a single bow, secured, however, to two shaped
plates
at the base, it also
guarantees good sliding stability
and can cover a space
of about
430mm
and a
MAXIMUM
of about
590mm.
