CABRIOLE’
CRAMARO TS S.r.l. – 37044 COLOGNA V.TA (VR) - VIA QUARI DESTRA, 71/G TEL. +39 0442/411688 / FAX + 39 0442/411690
E-MAIL [email protected] WEBSITE: http://www.cramaro.com -
Manual n° MCA016-EN-ED00 – date 15/01/15
page
24
FIG 31
FIG 30
The two side arms are made in two elements that are overlapped and bolted together; as such, their length can
vary to adapt to the actual conditions of the sheet length to install.
Once the container has been covered, simply proceed in hooking (for safety) the rear elastic tie rods to the specific
hooks (cobra) secured to the container
- VARIATIONS AND OPTIONALS -
For special applications,
CRAMARO TS
also has specific applications that are already ready to be put into service
with minimal, or even no, interventions on the container in question.
PRE-ASSEMBLED FRONT UNITS INTEGRATED IN ADAPTABLE CAB-SHIELDS
For the containers of some companies, there are both
MANUAL
and
ELECTRIC
front pulling units available, which
are already pre-assembled in a specific PROFILE that pairs perfectly with the front profile of the container.
MANUAL VERSION
ELECTRIC VERSION
Often, there are situations in which there is a
TOTAL LACK of FRONT CAB-SHIELD
and the presence of a
container lifting cylinder, which is taller than both the sideboards and the front upper profile of the container.
it is for these cases that
CRAMARO TS
has
developed and put into production a series of
COMPOSITE CAB-SHIELDS, adaptable to all the widths of
containers on the market and with the
central section in TUNNEL form
, so that the lifting cylinder can remain
completely covered or move freely without interfering with the cab-shield.
