CABRIOLE’
CRAMARO TS S.r.l. – 37044 COLOGNA V.TA (VR) - VIA QUARI DESTRA, 71/G TEL. +39 0442/411688 / FAX + 39 0442/411690
E-MAIL [email protected] WEBSITE: http://www.cramaro.com -
Manual n° MCA016-EN-ED00 – date 15/01/15
page
65
FIG 102
1
2
3
5
4
6
7
4
FIG 103
1
2
3
5
4
6
1
) Lower runner
2
) Bow end
3
) Lower pin
4
) Pulling rope
5
)
Upper pin
6) Washer
7) A.B. Nut Fastening
REPLACING "BOW SLIDING RUNNERS"
As we have just seen for removable pin replacement, the runner in anti-wear material inserted at the ends of all the
bows can also be easily replaced, even with the tarpaulin assembled (
you do not need to remove the sheet from
the container
)
Loosen the nuts located above the tarpaulin to replace the
WORN RUNNERS
and extract the
RUNNER, paying attention to the
REMOVABLE PINS
, which are also held by the same screw.
Once you have put the new runner screw back in to the holes through the sheet and the PEHD strip, properly tighten
the nut and the work is done
1
) Lower runner
2
) Bow end
3
)
Plastic pin
4
) Sheet
5
)
Washer
6) A.B. Nut Fastening
REPLACING THE "BOWS"
Replacing any damaged bows is as simple as ever by using removable end pins, making it completely unnecessary
to remove the ropes.
The operations to carry out are exactly the same as those that we have just seen to replace the sliding runners.
Once you have disassembled the damaged bow ends, simply extract it with caution from the lower sheet sleeve
containing it and, once you have inserted the new bow, reassemble the end elements.
