![background image](http://html1.mh-extra.com/html/cpi/s4uia/s4uia_installation-and-operation-manual_2674994092.webp)
L
B
AND
BUC
O
PTION
B-2
A
PP
.01040024
R
EV
.3
The Local Oscillator reference can be supplied in one of three formats below:
•
Multiplexed Local Oscillator reference frequency on the L-Band signal through the
type N RF input connector.
•
An internal LO reference integrated into the BUC.
•
An external LO reference through a separate BNC connector.
Multiplexed Reference
: Most L-band modems now have a built-in 10 MHz reference. The CPI
BUC can be configured to accept this reference, which is multiplexed with the L-band signal on
the same connector. This is CPI’s standard configuration, and it is recommended for most
applications. The level of 10 MHz should be +5 to -5 dBm at the amplifiers input.
Internal Reference
: An internal 10MHz reference signal with
±
1 ppm stability includes in the
BUC module. This oscillator performance is not as precise as a GPS reference, but it is adequate
for many applications.
External Reference
: This allows the user to connect a system 10 MHz reference through a BNC
cable. This is used for systems that need to slave all amplifiers to a common timing reference,
such as the GPS signal. The level required is +5 to -5 dBm.
Notes:
•
Refer to the Drawing section of the respective Service manual for more information
.
•
Refer to the amplifier specifications in the documents section of this manual for
performance of the amplifier with a BUC.
Precautions:
•
The modulator’s gain should be adjusted for the best signal to noise ratio (-60dBc).
Adding fixed attenuators at the modulators’ output can adjust the power level.
•
A multiplexer should be used rather than a combiner. In case of using a combiner,
band pass filters should be added to modems’ output or a 10 dB fixed attenuator can
be added to each combiner’s input.
•
Please take care to ensure that the proper L-band frequency range is not exceeded or
damage may result.
•
The L-band input signal must be free of the spurious signals that can cause poor
performance or even cause the amplifier to fail.
•
The level of 10 MHz should be +5 to -5 dBm at the amplifiers input.
Summary of Contents for S4UIA
