CPI S4UIA, Installation And Operation Manual

Page: 39 / 92

I
NITIAL
P
OWER
O
N
& C
HECKOUT
D
OC
.01040053 R
EV
.6
4-7
4.4.2 User Preference Settings
Before the Indoor SSPA is used at the installation site, these user configurable settings may be
set to the user’s requirements. Table 4-1 shows the user configurable preference settings.
Table 4-1. User Configurable Preference Settings
Name Setting System Setting Category
Amp Control Local or Remote System Control
RF Unit Watt or dBW or dBm RF Control
Mute Alarm Yes or No General
Mute Keypad Yes or No General
Auto Log Time in minutes General
Amp Address Set 48 to 111 Communication
Switch System None/1:1/1:1+M/1:1PC/1:2/1:2+M/1:2PC Switch Control
Amp ID 1 or 2 or 3 Switch Control
Amp Priority None or Amp1 or Amp2 Switch Control
BUC Unlock Alarm or Fault RF Control
High Refl RF Alarm or Fault RF Control
Reset Event Log Yes or No General
Fan Optimization Acoustic Noise or Enhanced Reliability Mechanical Control
Display Brightness 12.5% to 100% General
Screen Saver Yes or No General
Enable NTP Yes or No Time
CIF Serial Type RS-232 or RS-422 Communication
Serial CIF Protocol ASCII or Binary Communication
Relay 1 Can be set to any fault or alarm General
Relay 2 Can be set to any fault or alarm General
Relay 3 Can be set to any fault or alarm General
Relay 4 Can be set to any fault or alarm General
Press the
MENU
key to display the menu screen. Cursor over to
SETUP
using the arrow keys and
push
ENTER
. Cycle through the screens using the arrow keys to check that the default values
meet operator’s needs. Adjust if necessary or use
MENU
key to return to return to the main
screen on the front panel display.