![background image](http://html1.mh-extra.com/html/cpi/s4uia/s4uia_installation-and-operation-manual_2674994075.webp)
M
AINTENANCE
D
OC
.01040087
R
EV
.6
6-9
Power Sensor
& Meter
Synthesizer
Power Sensor
& Meter
Coupler
Coupler
High Power
Load
Indoor
SSPA
Figure 6-1. Performance Test Setup
Table 6-4. Power and Gain Test Data Sheet
Frequency
Measurements
Low Band
Center Band
High Band
Gain @ Rated
Small Signal Gain
6.5.2
RF Radiation Measurement
To measure the Indoor SSPA radiation levels:
1.
Adjust the Indoor SSPA for rated power.
2.
Using a radiation probe, measure the highest level of RF leakage around the amplifier, at less
then 12 inches away from any point source.
3.
Record the measured value(s). Measured levels should be less then 1mW/cm². If this value is
exceeded. Shut down the Indoor SSPA and tighten the joints or install grounding or gaskets to
eliminate leakage.
WARNING! IF ANY RF RADIATION LEVELS ARE TO BE MEASURED, CHECK FOR
RF LEAKAGE USING THE STEPS ABOVE.
Summary of Contents for S4UIA
