User Manual
TRU-S500DSP
Mono Channel DSP Amplifier
Thank you for purchasing TRU-S500DSP by
TruAudio. The 500 watt DSP amplifier has some
of the most advanced DSP functions available.
We have included DSP settings for all of our
passive subwoofers to get the highest perfor-
mance out of each subwoofer.
Installing Rack Mount Ears
If you are planning on installing this amplifier into a rack,
continue reading how to install the supplied rack ears.
1.
Use the supplied three screws to attach the supplied
rack ears to the TRU-S500DSP amp. If required, the feet
on the bottom of the amplifier can also be removed at
this time by unscrewing the mounting screws located in
the center of each foot.
2.
Due to the weight of the amplifier, it is recommended
that rear supports be
secured to the rear rack
rails. Hardware to do this
is not supplied with the
amplifier and is specific to
the type and depth of rack
being used.
1.
Power Switch:
Turns the amplifier on or off. Amplifier
must be on for the trigger or auto sense modes to
operate.
2.
16 Character x 2-row Liquid Crystal Display:
Shows
the amplifier’s status, menus and settings and works in
conjunction with the turn and push navigation controls
and the remote control.
3.
Programming Navigation Control:
Used to scroll
through the display menus, change setting and program
the DSP controller.
4.
Optional Rack Ears:
Two rack mount ears are
provided for rack mounting.
Back Panel
1.
Line Input:
For receiving line-level signals. Accepts
either a stereo or LFE signal.
2.
XLR Balanced Input:
For receiving balanced signals.
Accepts either a stereo or LFE signal
3.
12V Trigger Input:
For triggering the power on/off from
other devides such as processors or receivers that have a
12V trigger output. 6V minimum required for triggering.
NOTE:
Once in trigger mode, the amplifier cannot be
turned on without a 12V trigger signal. To disable the
12V trigger, press and hold the navigation control knob.
The power switch must be in the ON position. The
trigger mode will be turned off and the amplifier will
power on.
4.
Service:
For uploading new firmware or updates.
5.
IR Input:
Link to Infared (IR) hub.
Caution:
MAKE SURE TO READ THIS INSTRUCTION
MANUAL BEFORE TURNING THE POWER ON
OR HOOKING UP THIS POWER AMPLIFIER.
Description
TRU-S500DSP Amplifier Controls and Setup
Front Panel
TRU-S500DSP
1
2
3
4
TRU-S500DSP
ATTENTION
CAUTION
RISQUE DE CHOC ELECRIQUE
NE PAS OUVRIR
RISK OF ELECTRIC SHOCK
DO NOT OPEN
1
2
6
7
9
8
5
3
4
10
