13
CXO300
INSTALLATION MANUAL
4.0 MOUNTING THE OUTBOARD
4.8.0
Make sure that the water line of the vessel is between the lines which are shown on the
outboard in Figure 4.9.
Figure 4.8. Minimum and maximum water lines on the outboard engine.
4.9.0
Make sure that you read the information of the different leg lengths on multiple outboard
installs in Figure 4.9. It will help you put the PTT mountings in the correct position for
the correct steering geometry.
Figure 4.9 Different leg lengths on multiple outboard installations
4.10.0
When the positions for the center line(s) and height(s) are found.
4.10.1
Make marks at the positions of the six holes for the outboard(s).
4.10.2
Make sure that you use the supplied template (Servicing Kit No: 037023, figure 4.10) to get
the correct positions of the mounting holes.
4.10.3
Make sure that you use two bolts on each side for the six top holes.
4.10.4
Make sure that you use one bolt on each side for the bottom hole.
Max water line - make
sure that the exhaust
idle vent is out of the
water
Min water line - make
sure that the water
pump is covered for
correct operation
