Use and Maintenance Manual – 08/2018 Rel. 3
Page 26
110
Lower the wheel guard: the machine will run a launch.
120
At the end of the spin, the MOTO wheel type calibration is
finished and the machine will switch to NORMAL mode, ready to
run the balancing.
When the calibration is finished the MOTO wheel type and ALU1 Program Type value are set. Also the wheel data are automatically
set by machine for this type of calibration.
If you have anomalies during the calibration procedure, the machine will display the error message (for example
ERR 025
). See
chapter
“22. Error codes”
to solve the problem and continue/repeat/cancel the calibration in progress. Launches that are interrupted
by lifting the wheel guard can be repeated by lowering the wheel guard back down.
How to exit the MOTO wheel type calibration of the machine
At any time it is always possible to exit the calibration procedure during its progress by pressing [P5] key
. The calibration in
progress will be cancelled and the machine will use the values of MOTO wheel type calibration which were previously stored. Also in
this case the MOTO wheel type and the ALU1 Program Type will remain set. The wheel dimensions will be those which were
automatically set by the machine for this kind of calibration.
17. USE OF THE MACHINE IN NORMAL MODE
To use the machine, you must select or set as follows:
•
Program Type (program for wheels with steel, aluminum or special aluminum rim). Default = program for wheels with steel
rims;
•
Wheel type (auto-vehicle, motorbike, off-road). Default = auto-vehicle;
•
Dimensions of the wheel to balance. The dimensions can be partially (MEC 810VD) or fully (MEC 820VD) entered
automatically;
•
Dynamic or Static balancing. Default = Dynamic;
•
Display resolution X1 or X5. Default = X5.
The selections described above can be entered before or after the spin. For any variation of the selection or data settings, the machine
will run a calculation by displaying the new values of imbalance.
When the required selections/settings have been made it is possible to perform a launch by lowering the wheel guard. At the end of
the spin, the machine displays the wheel imbalance values.
Summary of Contents for MEC 810VD-VDL-VDBL
Page 2: ......
Page 77: ...Use and Maintenance Manual 08 2018 Rel 3 Page 72...