Cormach MEC 810VD-VDL-VDBL, Use And Maintenance Manual

Page: 10 / 78

Use and Maintenance Manual – 08/2018 Rel. 3 Page 5
6. INSTALLATION AND COMMISSIONING
After unpacking the various parts of the wheel balancer, ensure they are intact and check for any anomalies, then assemble the parts
by following the instructions provided below.
6.1 Installing display support
Figure F 6.1 and Figure F6.2: Unscrew nr. 4 M6 screws. Position the sheet metal support and clamp it on with 4 M6 screws.
Figure F6.3: Prepare the front plastic guard.
Figure F6.4 and Figure F6.5: Clamp the front plastic guard to the monitor with 4 M4 screws.
Figure F6.6 and Figure F6.7: Connect the power supply cables to the monitor. Couple the front plastic guard to the sheet metal
support.
Figure F6.8 and Figure F6.9: Clamp the front plastic guard to the sheet metal support with 3 M6 screws.