Use and Maintenance Manual – 08/2018 Rel. 3
Page 24
16.3 Machine calibration for the MOTO wheel type
The calibration for MOTO wheel type (motorcycle wheels) is completely separated from CAR/SUV wheel type because in the
calibration for MOTO a specific adaptor for motorcycle wheels is used and this slightly the shaft balancing.
If the calibration for MOTO wheel type has not been done and the user try to spin the wheel for balancing in the MOTO wheel type
mode, the machine will not run and will display an error code
ERR 031
.
To perform machine calibration for the motorbike flange, proceed as described below:
Phase
Description
010
Press [P1] or [P3]
on keyboard
and
select the icon relative to the program to be used.
020
Activate the MOTO calibration program by selecting
which will turn blue.
030
Confirm activation of the MOTO calibration program by pressing
[P6]
on the keyboard.
040
Mount the motorcycle adaptor on the shaft as shown here.
The flange for motorbike wheels must be installed so that the
“CAL” markings on the shaft flange and the flange for
motorbikes line up.
Summary of Contents for MEC 810VD-VDL-VDBL
Page 2: ......
Page 77: ...Use and Maintenance Manual 08 2018 Rel 3 Page 72...
