Copystar Ri 2530, Service Manual

Page: 520 / 686

3CM
1-3-7
Maintenance
Description
item No.
U603 Setting the user registration data
Description
Makes user settings to enable the use of the copier as a fax.
Purpose
To be run after installation of the facsimile kit if necessary.
Start
1. Press the start key. The screen for selecting an item is displayed.
2. Press the appropriate item.
The screen for the selected item appears.
Sets the self telephone number.
Sets the type of telephone line.
Sets the number of rings in fax/telephone auto select mode.
Sets remote diagnostic transmission.
Display
SELF TEL No.
LINE TYPE
RINGS (F/T) #
REMOTE DIAG
Description
Setting the self telephone number
1. Enter the telephone number using the numeric keys.
Up to 20 digits can be entered.
To correct the entered telephone number or to delete the stored telephone number, reset by pressing the
stop/clear key.
2. Press the start key.
3. To return to the screen for selecting an item, press the stop/clear key.
The item-selection screen does not reappear until registration or deletion processing is completed.
Setting the type of telephone line
1. Change the setting using the numeric keys.
DTMF
10 PPS
20 PPS
Display
1: DTMF
2: 10
3: 20
Description
2. Press the start key. The value is set.
3. To return to the screen for selecting an item, press the stop/clear key.
Setting the number of rings in the fax/telephone auto select mode
Use this if the user wishes to adjust the number of rings that occur before the unit switches into fax receiving
mode when fax/telephone auto-select is enabled.
1. Change the setting using the numeric keys.
0 to 15
Description
Number of fax/telephone rings
Setting range
If you set this to 0, the unit will start fax reception without any ringing.
2. Press the start key. The value is set.
3. To return to the screen for selecting an item, press the stop/clear key.
Setting remote diagnostic transmission
1. Enter 1 or 2 using the numeric keys to select if remote diagnostic transmission is to be enabled.
Remote diagnostic transmission is enabled.
Remote diagnostic transmission is disabled.
Display
1: ON
2: OFF
Description
2. Press the start key. The value is set.
3. To return to the screen for selecting an item, press the stop/clear key.
Completion
Press the stop/clear key at the screen for selecting an item. The screen for selecting a maintenance item No. is
displayed.