Copystar Ri 2530, Service Manual

Page: 35 / 686

2DF
1-3-15
1-3-4 Installing the key counter (option)
Key counter installation requires the following parts:
Key counter set (P/N 2A369703)
Contents of the set:
• Key counter cover (P/N 2A360010)
• Key counter retainer (P/N 66060030)
• Key counter cover retainer (P/N 66060022)
• Key counter mount (P/N 66060040)
• Key counter socket assembly (P/N 41529210)
• Four (4) M4
×
6 bronze TP-A screws (P/N B4304060)
• Two (2) M4
×
10 bronze TP-A screws (P/N B4304100)
• One (1) M4
×
20 bronze TP-A screw (P/N B4304200)
• One (1) M4
×
6 chrome TP-A screw (P/N B4104060)
• One (1) M3
×
8 bronze binding screw (P/N B1303080)
• One (1) M4
×
30 bronze binding screw (P/N B1304300)
• Two (2) M3
×
6 bronze flat-head screws (P/N B2303060)
• One (1) M3 bronze nut (P/N C2303000)
Procedure
1. Fit the key counter socket assembly to the
key counter retainer using the two screws
and nut.
2. Fit the key counter mount to the key counter
cover using the two screws, and attach the
key counter retainer to the mount using the
two screws.
3. Remove the three screws holding the middle
right cover and then the cover.
4. Cut out the aperture plate on the middle right
cover using nippers.
5. Pass the connect inside the copier through
the aperture and refit the middle right cover.
Figure 1-3-12
Figure 1-3-13
Key counter retainer (66060030)
Key counter mount (66060040)
Key counter cover
(2A360010)
M4
×
6 screws (B4304060)
M4
×
6 screws (B4304060)
M3 nut
(C2303000)
M3
×
6 flat-head screws (B2303060)
Key counter socket assembly
(41529210)
Aperture
Middle right cover
Connector