—
M2M Gateway Basic Settings
—
M2M Gateway PLC Communication Settings
—
16
—
3.
Time Synchronization Settings
This section describes time synchronization settings.
*Notice Regarding Time Settings
The M2M Gateway models listed below has no back-up power supplies (batteries) within the
controller. Therefore, the time information cannot be kept when shutting down or rebooting the
controller. Time synchronization is required depending on the intended use.
Also, note that functions such as logging the PLC collected information will not work if the time
synchronization is not yet successful.
- CPS-MG341-ADSC1-111
- CPS-MG341G-ADSC1-111
Time Synchronization
Web access the CONPROSYS, and go to the [Setting] and select the [Time] to open the setting page.
After completing the settings, click the [set] button. This saves the settings temporarily.
To save the settings on the CONPROSYS, perform the [Save]. This saves the contents into ROM.
To reflect the changed contents, perform the [Reboot].
Performing the [Save and Reboot] can simplify the actions.
Refer to the "4. Saving the Settings" for further details.
Click the [Set the PC Time] to set the time on the operating PC.
Use this when the NTP server cannot be connected in the environment such as for a test operation.