ConMed sabre 180, Service Manual

Page: 11 / 72

1.2 SPECIFICATIONS
MAINS INPUT REQUIREMENTS:
•Single Phase AC / 48-62 Hz / 200W
•Power Cord: 3 conductor, #18 AWG (1.5mm2) Cu, CEE22 250V 6A Mains Connector
MAINS FREQUENCY LEAKAGE:
•Chassis: <100 uA IEC Class 1, Type CF, Defibrillator Proof
•Patient: <10 uA
RF OUTPUT SPECIFICATIONS:
RF LEAKAGE: <100 mA, RF ISOLATED
DUTY CYCLE: 15s ON, 30s IDLE
COOLING: Natural convection, no fan
1-5
•The heat dissipation capability of the heat sink is
severely impaired by activating the Sabre 180 in
other than its normal operating position. There
are no tests requiring operation in any other posi-
tion.
•Consult the factory for advice before making
any modifications to the unit.
•Ensure that the RUN-RST-CAL switch is set to
RUN and that the two top cover screws are tight-
ened before returning the unit to service.
MAX. OPEN
MAX. RATED CARRIER CREST FACTOR CIRCUIT PULSE
POWER LOAD FREQ. 50% POWER VOLTAGE REPETITION
MODE WATTS OHMS KHz RATED LOAD VPP FREQ. KHz
CUT PURE 100 500 417 1.8 1600 CONTIN.
CUT BLEND 1 65 500 417 2.3 1650 20 KHz
CUT BLEND 2 50 500 417 3.5 1750 20 KHz
MONO. COAG 80 500 540 7.0 6500 33 KHz
BIPOLAR COAG 50 50 1050 2.4 400 20 KHz
MAINS VOLTAGE CURRENT
VRMS ARMS
CATALOG NO. RATED MIN MAX MAX IDLE
60-5800-001 120 104 127 2.4 0.5
60-5800-002 100 90 110 2.9 0.6
60-5800-003 230 208 254 1.3 0.3
F