26
CONFIGURING THE VXH264D
SYSTEm
The VXH264D can be remotely controlled using a concept Pro VA- keyboard. Up to
254 VXH264Ds can be controlled using a single VA- PTZ controller.
SySTem ID: If more than one VXH264D is connected on the same RS485 bus, each one must
have a unique ID.
PRoTocol: must be set to VA-.
bAUD RATe: must be set to match the baud rate of the VA- PTZ controller.
SySTem: conTRol DeVIce
The VXH264D can be linked in to a till system to allow this, set up the configuration on this
menu – PoS SeTUP
SySTem: PoS SeTUP
SySTem nAme: A system name of up to 15 characters can be defined. It is used so that
notification emails can be identified.
F/w UPGRADe: Firmware updates may be released periodically to enhance system
performance and add extra features. The operator can upgrade the firmware using a USb
memory stick.
FAcToRy DeFAUlT: If settings have been changed which causes erratic behaviour, the factory
default settings can be loaded.
SySTem DATA: System settings can be saved to a USb memory stick. The settings can be
reloaded in case of accidental factory reset or can be transferred to another VXH264D if multiple
units need to be installed with the same settings. All information is saved including network
settings and system name.
PASSwoRD: Selects if a password is required ‘on / oFF’.
Please note: Password must be selected to ‘on’ if USeR mAnGemenT options are required.
PAnel leD: Select to turn ‘on/oFF’ the leDs on the front panel.
PoS enAble
PRoTocol
bAUDRATe
TcP PoRT
AlARm TRIGGeR
TRIGGeR TeXT 1
TRIGGeR TeXT 2
TRIGGeR TeXT 3
TRIGGeR TeXT 4
TRIGGeR TeXT 5
PRoTocol RS485 (1cH)
cHAnnel
PRoTocol RS485 (AVe)
cHAnnel
ADDR / PoRT
PRoTocol neT (TcP)
cHAnnel
ADDR / PoRT
on / oFF
RS485 (1cH) / RS485 (AVe) / neT (TcP
9600
[PoRT nUmbeR]
oFF / AlwAyS / TeXT
[enTeR TeXT]
[enTeR TeXT]
[enTeR TeXT]
[enTeR TeXT]
[enTeR TeXT]
1 ~ 16
1 ~ 16
[enTeR PoRT]
1 ~ 16
[PoRT DISPlAyeD DePenDInG on TcP PoRT SeT
PReVIoUSly]
