Conair TrueBlend TB500-4, User Manual

Page: 72 / 150

Operation TrueBlend ™
70 Edition: February 2007
7.9.1 Input of material percentages
Î Input the percentage for the material
component by pressing the input field
beside "Percent %".
Î Input the value with the numeric key-
pad. Note: If using multiple naturals,
they must equal 100%.
Î
Confirm the value with .
The metering rate in g/s is automatically
learned by the system, but by completing a
manual calibration the blender hones in on
the rate with greater precision.
7.9.2 Input of Material type
Î After "Mat. type" input the component
for the supply hopper.
Î Select the desired component --- (a
series of three dashes indicates an un-
used hopper and can be assigned to
any position. It is important to note that
if you are not using a hopper, material
type must be set to “---“), regrind, natu-
ral material, additive batch, additive
natural, or Precision Additive™
(The Precision Additive™ can only be
assigned to one additive natural posi-
tion on the blender.)
Î Factory default settings are position 1,
Reg.; position 2, Nat.; position 3, AddN;
position 4, AddN; position 5 (if applica-
ble), Off; position 6 (if applicable), Off.