Conair TrueBlend TB500-4, User Manual, Page: 49 / 150

TrueBlend ™ Operation
Edition: February 2007 47
7.4 Starting and stopping the blending process
7.4.1 Starting blender process (with set values or factory setting)
Î
Press the blender icon.
The “TrueBlend Status” screen opens.
Î Press the button to start the blending
process automatically with the last set values
or the factory settings.
The button signals . (green bar)
7.4.2 Stopping the blending process
Î
Press the button to stop the metering
and mixing process.
The button changes to (yellow bar). The
current batch will run until it is finished. When fin-
ished the display changes to (gray bar).
7.4.3 Restarting after EMERGENCY STOP
Î Switch the main power switch on.
Switching on within two minutes : the unit continues the interrupted process. This
function is used to keep downtime in the event of a short power interruption as short
as possible. The screen that was last open before switching off or power failure is
opened.
Switching on after more than two minutes: the internal functions are completely
reset after switching on. The start screen appears.
NOTE
If the metering cycle is interrupted, the material in the weigh bin must be re-
moved manually before restarting.
This will prevent an incorrect mix ratio.
Î Remove the weigh bin carefully to prevent damage to the load cell and
empty it (see also 7.12).