To configure the parameters, please reference
Outgoing
table above.
7.4.2 MAC
Filter
MAC Filtering is only effective on ATM PVCs configured in Bridge mode.
This MAC Filter page allows access to be restricted/allowed based on a MAC
address. All NICs have a unique 48-bit MAC address burned into the ROM chip on
the card. When MAC address filtering is enabled, you are restricting the NICs
that are allowed to connect to your access point. Therefore, an access point will
grant access to any computer that is using a NIC whose MAC address is on its
“allows” list.
When a device is using MAC filtering, any address not explicitly defined will be
denied access.
MAC Restrict mode:
Off
- disables MAC filtering;
Allow
–
permits
access
for the
specified MAC address;
deny
; reject access of the specified MAC address, then
click the
SET
button.
To delete an entry
,
select the entry at the bottom of the screen and then click the
Remove
button, located on the right hand side of the screen.
To add a MAC entry, click
Add
and enter MAC address.
- -
48