Comtech EF Data / Stampede
FX Series Administration Guide - Version 6.2.2
126
Chapter: FX Series Status
Section: QOS Monitors
MN-FXSERIESADM6 Rev 6
6.2.2
QOS Queue Monitor
The QoS Queue Monitor provides a real time view of vital QoS statistics, including current, average and elapsed
stats for each defined queue. When navigating to the page from the top level menus, all the queues, sorted by
priority, are shown. When navigating to the page from the queue tab on the link monitor screen, only the queues
associated with that link are displayed. The statistics on this page are given for each queue in one of three modes:
current, time average and since last reset.
Figure 6-5 FX Series QoS Monitor by Queue
Priority:
This is the assigned priority and queues are sorted in this list by priority.
Header Compression
:
The parameters for this field are:
Disabled – if no compression is enabled.
HC – if only header compression is enabled.
PL – if both header and payload compression are enabled.
Error: code – Indicates an error. The codes for the errors are as follows:
3 – This code means that the packet compressor function was unable to establish a tunnel
with a peer. Possible reasons for this are:
· The wrong MAC address was specified.
· There is a routing problem.
· The target peer is not in the path of the data flow.
· The peer is not connected to the network perhaps due to faulty or disconnected
Ethernet cable.
