Comtech EF Data / Stampede
FX Series Administration Guide - Version 6.2.2
104
Chapter: FX Series ADC General Settings
Section: Redundancy
MN-FXSERIESADM6 Rev 6
4
FX Series ADC General Settings
This chapter discusses the General Settings of the FX Series ADC appliances.
Figure 4-1 FX Series ADC General Edit Screen
FX Series ADC in ‘Configuration-Only’ Mode:
This setting is useful if you are in the process of configuring your FX Series ADC while the unit is
networked in-line. In “Configuration-Only” mode the in-line networking card is put into “bypass” mode so
that traffic is simply passed through. When you are satisfied that the FX Series ADC is properly configured
you can disable this setting. This setting only applies if the ‘Traffic interception mode’ is set to “In-Line” or
“WCCP”, this setting is ignored if the ‘Traffic interception mode’ is set to “routed”. The default setting is
“Off”.
