Comtech EF Data CDM-800, Installation And Operation Manual

Page: 117 / 130

CDM-800 Gateway Router Revision 1
Serial-based Remote Product Management MN-CDM800
6–9
These Instruction Codes are explained in complete detail in the tables that follow. Note that the Target ‐ to ‐ Controller Instruction Code
Qualifiers, described earlier, that appear in the “Response to Command” column carry the following meanings:
= Message OK.
? Received OK, but invalid arguments were found.
* Message OK, but not permitted in current mode.
# Message OK, but unit is not in Remote mode.
! Invalid instruction.
Parameter
Type
Command
(Instruction
& Qualifier)
Number of
Arguments
Description of Arguments
Response to
Command
Query
(Instruction &
Qualifier)
Response to Query
Default
Passwords DPW= N/A
Command Only.
Resets the admin username/password to:
Username = “comtech”
Password = “comtech”
DPW=
DPW?
DPW*
DPW#
N/A N/A
GE1 Address IG1= 18 bytes numerical Command or Query.
Sets the IP Address and network prefix for the 10/100/1000 BaseT GE1 Ethernet
port, in the form aaa.bbb.ccc.ddd/yy, where:
(Permitted ranges – cannot all be zero)
aaa = 0-223
bbb = 0-255
ccc = 0-255
ddd = 0-255
yy = network prefix (range: 8 to 31)
Other restrictions:
If aaa>191, prefix may not be less than 24.
If aaa>127, prefix may not be less than 16.
Example: IG1=010.006.030.001/24
IG1=
IG1?
IG1*
IG1#
IG1? IG1=xxx.xxx.xxx.xxx/yy
(see Description of Arguments)