Comtech EF Data CDM-800, Installation And Operation Manual

Page: 106 / 130

CDM-800 Gateway Router Revision 1
Ethernet-based Remote Product Management MN-CDM800
5–46
o
Then, use the top (Save) Select Location dropdown to select 1 through 10.
o
Finally , click [Save Configuration] to store the configuration settings.
•
To load (recall) a configuration set:
o
First, use the bottom (Load) Select Location dropdown to select 1 through 10 .
o
Then, click [Load Configuration] to recall the selected configuration settings.
BERT Config
(Where BERT is the acronym for Bit Error Rate Test) Use the drop ‐ down menus to:
•
Configure the Tx BERT State as On or Off .
•
Configure the Tx or Rx BERT Pattern as 2^23 ‐ 1 (2
23
‐ 1) or 2047 .
•
Set Error Insert(ion) as either Off or 10E ‐ 3 .
Click [Submit] to save the BERT settings and execute the test.
Once the Tx BERT is executed, the entire outbound carrier transmits a BERT pattern.
All IP communications are halted during this test.
Note also that the Rx BERT State for the CDM ‐ 840 Remote Router must be enabled
to properly receive and monitor the BERT pattern.
Redundancy
•
Current Redundancy State ( read ‐ only ) – Status is listed as On Line or Off Line .
•
Offline Unit Status ( read ‐ only ) – This indicates the status of the offline unit.
If the unit is not connected to a redundancy switch, the status is listed as No_1F1 .
Otherwise, its status is listed as On Line or Off Line .
If the unit is part of a 1:1 or 1:N redundant pair of CDM ‐ 800s, and this unit is currently On Line ,
click [Force Redundancy Switch] to cause the unit to switch to standby.