ComStream CM601, Installation And Operation Manual

Page: 82 / 228

6-10 Front Panel Operation
For example, to reduce the acquisition range from 30000 Hz to 10000 Hz, the
LCD will appear as follows:
Initial display of :AA command :AA
Use the terminal emulator function to type the remote syntax
AR 10000
Display after command is typed
:AR 10000
To issue a command using the terminal emulator:
1. Navigate to the terminal emulator :AA command using the LCD, Cursor, and
Modify buttons.
2. Press the right LCD button or the Cursor buttons to select the command.
3. Enter the command using terminal emulator syntax.
a. If the character that you want to change is not flashing, use the Cursor
buttons to make it flash.
b. Scroll through the list of characters using the Modify buttons. The
characters display in the following order:
• Space
• ? (question mark)
• - (hyphen)
• , (comma)
• 0 through 9
• A through Z
c. Repeat steps a and b until the entire command appears as desired.
4. Issue the command by pressing the Enter button.
If the command was a query, the LCD will display the response for a few
seconds and then redisplay
:AA .
If the command was successfully executed, the LCD will redisplay
:AA
.
If an error occurs, the LCD will display an error message for a few
seconds and then redisplay
:AA
.
Command Summary
Table 6-6 lists the front panel commands for a standard CM601 with no installed
option cards. These commands are summarized in the order in which they appear
in the command tree, from top to bottom, and then left to right. Included are:
Level to which the front panel command is attached
Front panel command
Remote command equivalent and memory type
Command function
Either the parameters available for the front panel command or the response
format for the monitor and status commands
This table is also provided as a quick reference card.