ComStream CM601, Installation And Operation Manual

Page: 66 / 228

5-8 Remote Commands and Error Codes
FR Fault Relay Sense Config (NV) 0 = normal
1 = inverted 0 Changes the polarity of the Form-C status relay
accessed through the J2 connector on the rear
panel of the CM601.
FRX Fault Relay Sense
External Signal
Polarity Config (NV) <condition> parameter = 0 to 7
bit settings:
0 = normal polarity
1 = inverted polarity 0 (bit setting) Defines whether a fault condition is a closed or
an open relay contact for each of the three
external fault relay sense pins on the Status
Relay rear panel connector.
GAV Gate Array Version Monitor syntax is n:GAV ? where n =
1, 4, or 5 — Displays the version of the installed EPROM by
slot.
HWV Hardware Version Monitor syntax is n:HWV ? where
n = 1, 4, or 5 — Displays the hardware version of any card in
the modem by slot; response format:
<slot#>:V<version number>.
ID Modem
Identification Config (NV) 1 to 24 ASCII characters ComStream
CM601 Assigns an arbitrary, 24-character ASCII string
used to identify the modem.
IN Initialize Modem Config (V) 9346 — Initializes all modem configuration parameters
to their default states, stores them in NV
memory, and then performs a complete modem
reset.
INF Initialize New
Firmware Config (V) 9346 — Initializes and resets all option cards; all
configuration parameters are returned to their
default settings and the NV memory map is
reconfigured. Use this command anytime new
firmware is added to any CM601 card,
including M&C firmware, to ensure proper
operation after installation.
LB Loopback Mode Config (V) 0 = disable
2 = near data
4 = far data 0 Tests and troubleshoots system connections.
LBT LCD Backlight
Timeout Config (NV) 0 = always off
1 to 19 = minutes to time-out
20 = always on — Sets the number of minutes until the front panel
LCD backlight is automatically turned off
LCC LCD Contrast Config (NV) 0 to 10 with 0 = lightest setting,
10 = darkest setting Adjusts the contrast on the front panel LCD.
LGE Login Security
Enable Security (NV) 0 = disable
1 = enable 0 Enables and disables the remote login port
security function.
LGN Login Security (V) 1 to 8 alphanumeric characters,
no embedded spaces password Logs in to the remote port and establishes
normal communications with the CM601. When
LGE is set to 0, this command is not available
and returns an error message.
LGT Logout Security (V) — — Logs out from the remote port; use this
command if LGN was used to establish
communication.
LIT Login Inactivity
Time-out Security (NV) 0 = disable
5 to 255 60 Sets the number of seconds of inactivity
allowed before automatic logout occurs.
LPW Login Password Security (NV) 1 to 8 alphanumeric characters,
no embedded spaces — Changes the remote port login password.
MB Modulator Bit
Timing Config (NV) 1 = external timing
2 = internal timing
3 = loop timing 2 Establishes the source of the modulator bit
time, transmit data clock. The DTE must
provide the CM601 with send data (SD) that
transitions on the rising edge of the selected
transmit clock.
Table 5-3 Command Summary (continued)
Command
Mnemonic
Command Name
Function
(Mem Type)
Parameter Range Default Description and Notes