. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-24
Server Management
Writer: Project: Server Management Comments:
File Name: D-ch2.doc Last Saved On: 4/23/97 11:14 AM
Compaq System Configuration Utility Pager Settings
for Booting into Compaq Utilities
continued
Pager Data
Setting
Description
Network
protocol
To use IPX network access, set Network Protocol to IPX.
When the system restarts to the Compaq Utilities
because of an ASR reset, it loads IPX network support.
This enables remote access via NVT.
To use IP network access, set Network protocol to IP.
Also make sure to set Network IP address, Network IP
net mask, and Network IP router address. When the
system restarts to the Compaq Utilities because of an
ASR reset, it loads IP network support. This enables
remote access via Telnet.
NOTE: The Network Status must be set to Enabled for
network access.
Network
controller
Compaq
For all Compaq Standard Network Controllers.
Network
host name
CPQHOU
Enter the network name of the server. Use underscores
instead of spaces within the name; for example,
Compaq_Server. If you are using IPX network access to
the Compaq Utilities, this server name is used to
advertise NVT host services. This server name displays
in the Compaq Insight Manager server list when it
determines it can communicate via NVT. Set this name
to be the same as the server name you assign when the
host OS is running.
Network
card slot
Slot #
Select the slot number of the network interface card
you wish to use for network access to Compaq Utilities.
continued