5-94
Removal and Replacement Procedures
5.2.18 Compaq Logo
The Compaq logo is secured to the front bezel with adhesive. To replace the logo, complete the
following steps:
1. Remove the access panel as described in Section 5.2.3.
2. Remove the front bezel as described in Section 5.2.17.1.
3. From the inside of the front bezel, use a small screwdriver at the hole shown in the figure to
push the logo out of the front bezel.
4. Use a clean cloth to clean the recessed area in the front bezel where the logo is to be installed.
5. Remove the protective cover from the back of the replacement logo and press it into place.
Figure 5-85.
Installing the Compaq Logo on a Minitower
If the original logo is missing, complete steps four and five to replace the logo without removing the
unit cover assembly.
Summary of Contents for Deskpro 2000 Series
