Compaq Deskpro 2000
5-91
5.2.17 Front Bezel Assembly
When removing or installing the power supply or any mass storage device, you must first remove the
front bezel.
5.2.17.1 Front Bezel
The front bezel is mounted to the computer cover with release latches that are integrated into the bezel.
To remove the front bezel, complete the following steps.
1. Perform the preparation procedures described in Section 5.2.3.
2. Remove the access panel as described in Section 5.2.6.1.
3. From inside the chassis, push the release latches
1
in and push the side of the bezel out and away
from the chassis
2
to release the bezel at those points.
4. Rotate the bezel out from the chassis, then slide it to the left.
5. Separate the bezel from the chassis.
Figure 5-82.
Removing the Front Bezel
To replace the front bezel, reverse the above steps, taking care to properly position the hinge points
and the release latches before pushing the bezel back into the chassis.
Summary of Contents for Deskpro 2000 Series
