Compaq Deskpro 2000 Series, Maintenance & Service Manual

Page: 142 / 285

Compaq Deskpro 2000 5-29
5.1.11.2 Cirrus Logic 5446 Graphics Controller
To install additional memory onto the Cirrus Logic 5446 Graphics Controller board, complete the
following steps:
1. Perform preparation procedures described in Section 5.1.3.
2. Remove the system unit cover (Section 5.1.6).
3. Remove the expansion board (Section 5.1.8).
4. Place the graphics board on a flat surface and install the upgrade module.
✎
Ensure that all pins on the connector are properly aligned to avoid damaging the memory module
and/or the graphics controller.
If you are removing a memory module, rock the module gently while pulling it up.
Figure 5-25. Installing a Memory Upgrade Module on the Cirrus Logic Graphics Board
5. Replace the graphics controller board in the same expansion slot, securing it with the previously
removed screw.
6. Replace the system unit cover.
7. Turn on the computer and start the Windows program.
8. Select the Display icon in the Compaq Utilities group box in Windows NT 3.51 or Windows 3.1, or
the Display icon in Windows 95, to take advantage of the additional display modes now available
with the upgraded memory. Follow the instructions on the screen.
9. Test the system (optional) using the Computer Checkup (TEST) utility. Refer to Chapter 2,
“Troubleshooting.”