Repair and Replacement
6-13
Compaq Confidential – Need to Know Required
Writer: Hilary Stead Project: Compaq StorageWorks SAN Switch 8 Installation and Hardware Guide Comments:
Part Number: EK-BCP24-IA / 161355-001 File Name: G-CH6 REPAIR AND REPLACEMENT.DOC Last Saved On: 9/30/99 10:31 AM
8.
Replace the switch’s cover. See “Replacing the Switch Cover,” earlier in
this chapter.
9.
Reinstall the GBIC modules. See “Installing a GBIC Module,” earlier in
this chapter.
10.
Reconnect all external cabling.
11.
Turn on the switch’s power supplies. The switch automatically runs
POST.
12.
Check for error messages through Telnet.
Replacing the Chassis
To replace the chassis assembly, you must remove the switch’s
GBIC modules, cover, motherboard, power supply or supplies, and fan
assembly from the current chassis, and install them into the new chassis
assembly.
Removing the Switch Components
To remove the switch components:
1.
Turn off the power to the switch.
2.
Remove all external cabling from the front panel.
3.
Remove the power supply or supplies. See “Removing the Power
Supply,” earlier in this chapter.
4.
Remove all GBIC modules. See “Removing a GBIC Module,” earlier in
this chapter.
5.
Remove the switch cover. See “Removing the Switch Cover,” earlier in
this chapter.
6.
Remove the fan assembly. See “Removing the Fan Assembly,” earlier in
this chapter.
7.
Remove the motherboard. See “Removing the Motherboard,” earlier in
this chapter.
