6-12
Compaq StorageWorks SAN Switch 8 Installation and Hardware Guide
Compaq Confidential – Need to Know Required
Writer: Hilary Stead Project: Compaq StorageWorks SAN Switch 8 Installation and Hardware Guide Comments:
Part Number: EK-BCP24-IA / 161355-001 File Name: G-CH6 REPAIR AND REPLACEMENT.DOC Last Saved On: 9/30/99 10:31 AM
10.
Lift the back end of the motherboard about 45° over the metal guides
and slide it back until it lifts out of the chassis.
Figure 6-9. Removing the motherboard
11.
Remove the new motherboard from its antistatic bag and place the old
motherboard into the bag.
Installing the Motherboard
1.
Lay the serial port ribbon cable to the side by placing it over the power
supply.
2.
Tilt the front end of the motherboard down about 45° and slide it into
the front panel of the switch. Lower the rear end of the motherboard so
that the metal guides on the chassis fit into the slots on the motherboard.
3.
Slide the motherboard forward against the front panel until the screw
holes line up.
4.
Install the four Phillips screws into the motherboard. The #4 Phillips
head screw goes into the center back hole on the motherboard and the
#2 Phillips head screws go into the three holes at the front of the
motherboard.
5.
Reconnect the serial port ribbon cable to the motherboard. The cable
connector is keyed with the red strip going to pin 1 on the connector and
gently lay the excess ribbon cable between the motherboard and chassis
to prevent cable damage.
6.
Reconnect the power supply connectors.
7.
Reconnect the fan assembly connector.
