74
State Activity
When you setup the LACP aggregator, you can configure port state activity. You can select or
deselect the port. When you mark the port and select
button the port state activity
will change to
Active
. Opposite is
Passive
.
Active:
The port automatically sends LACP protocol packets.
Passive:
The port does not automatically send LACP protocol packets, and responds
only if it receives LACP protocol packets from the opposite device.
Note
1.
A link having either two active LACP ports or one active port can
perform dynamic LACP trunk.
2.
A link has two passive LACP ports will not perform dynamic LACP
trunk because both ports are waiting for an LACP protocol packet
from the opposite device.
3.
If you are the active LACP’s aggregator, after you have selected trunk
port, the active status will be created automatically.
Port Trunk – State Activity interface
Summary of Contents for CNGE8FX4TX4MS
Page 6: ......
Page 60: ...54 Main interface Main interface...
Page 99: ...93 QoS Configuration interface...
