C25000 O&S Manual
23
C25000-OM-EN-05
Warning
Workplace situations are constantly changing. Check the work area before
beginning each shift. If in doubt, consult with the relevant supervisor.
Failure to observe new workplace conditions can lead to serious injury or
death.
2.20: Adjusting Load Forks
(Optional Fork Positioning)
Forks should be spaced as far apart as the load being moved will allow.
Both forks should always be the same distance from the centre of the fork
carriage.
To adjust, raise forks approximately 100mm (4”) off the floor.
Apply parking brake.
Move the forks to the desired position by pressing the auxiliary button on
the fork control joystick and moving the joystick left of right.
2.21: Work Place Operating Conditions
Operators must be aware of special situations in their workplace in order to
avoid forklift accidents. Even if an operator works in the same area every day,
there could be changes that affect safety, such as:
Contractors doing maintenance
Wet areas
Overhead repair work
Be on the lookout for anything that might present a hazard such as:
Potholes
Pedestrian traffic
Very narrow aisle ways
Overhead obstructions
Poor lighting making it hard to see hazards
Wet, oily, or rough terrain
Other equipment or vehicles operating in the area
Remember:
Do not block any of the following safety critical items/areas with
the truck or the materials being handled:
Electrical panels
Fire exits
Emergency stop buttons
Aisle ways
Fire extinguishers/hoses
