C25000 O&S Manual
22
C25000-OM-EN-05
Retract mast if operating in confined spaces.
Drive rearward until machine is clear of load
2.17: Double Forking
If it is not possible to engage forks fully when lifting a load it will be necessary
to move the load closer to the front of the machine before lifting. This can be
achieved by double forking the load.
NOTE
The lift capacity of the Combilift is reduced if the forks are not fully engaged.
To Double Fork a Load:
Raise the load slightly and retract the mast sufficiently to bring the load
closer to the machine.
Lower the load and extend the mast again until the load is against the fork
face.
The load is now ready to be lifted.
2.18: Stacking
Slowly approach stack with load
retracted and tilted backwards.
Stop at face of stack, select neutral
and apply parking brake.
Elevate load until clear of stack top.
Operate accelerator pedal to ensure
that engine speed is sufficient to
prevent stalling and to give the
required lifting speed.
Extend mast until load is above the
stack.
Tilt mast to vertical position and lower
load onto stack.
Retract mast fully and lower forks to
150mm (6”) above ground before
moving off.
2.19: De-Stacking
Approach stack with mast retracted and in vertical position.
Stop at face of stack, select neutral and apply parking brake.
Elevate forks to permit entry into pallet.
Extend mast and enter the pallet with the forks.
Elevate load until clear of stack and tilt mast backwards to stabilise load.
Operate accelerator pedal to ensure that the engine speed is sufficient to
prevent stalling.
Retract mast fully and lower load to 150mm (6”) above ground, or where
possible on to the platforms.
