C25000 O&S Manual
16
C25000-OM-EN-05
2.3: Load Chart
The rated capacity of the truck is illustrated
on a load chart located inside the cabin. The
load centre is determined by its centre of
gravity and is measured from the front face
of the forks to the centre of gravity of the
load. It is assumed that the centre of gravity
in the vertical direction is no greater than the
specified horizontal load centre.
It is the responsibility of the operator to determine that the weight of the load to
be handled is not greater than the capacity shown on the load chart. The
operator
must not
handle any load that is greater than the capacity shown.
2.4: Operator Qualification and Responsibilities
The operator of the Combilift must be qualified to operate the truck
through successful completion of a training program delivered by
Combilift Driver training personnel or a Combilift authorised training
organisation.
Operators shall be aware of all local authority regulations and laws
regarding the qualification of material handling equipment operators.
No one shall operate the truck if impaired due to intoxication or drug
reaction.
Always ensure that the truck is in good working order before
commencing work. This is achieved by performing the pre-use
inspection. The inspection is to be carried out at the beginning of the
working day or at the start of each shift.
It is the operators responsibility to perform the pre-use inspection
before each shift. The Inspection and how it should be conducted is
covered later in this publication.
Operation of the truck controls is only permitted when the operator is
sitting on the operators seat in the cabin with the seatbelt buckled and
the cabin door closed and latched securely.
Never place any part of the body outside the confines of the cabin
when operating the truck.
Diagnosis and repair of the truck shall be performed by trained
competent technicians unimpaired by intoxication or drug reaction.
Unless authorised and trained to do so, the operator must not attempt
any repairs, but report defects immediately. When authorised to
perform maintenance work and/or repairs, ALWAYS ensure that the
appropriate Health and Safety regulations are strictly adhered to.
COMPLYING WITH 89/392/EEC
MAXIMUM STACKING CAPACITY ON A FIRM LEVEL SURFACE
600
700
L
I
F
T
HEI
GH
T
(
m
)
2.5
4.5
LOAD CENTRE (mm)
800
900
?Kg
5.5
1000
?Kg
?Kg
?Kg
?Kg
?Kg
?Kg
?Kg
?Kg
