C25000 O&S Manual
47
C25000-OM-EN-05
7. Insert the primary filter. Slide the filter down at
approximately a 5° angle until it hits the end of
the housing. Rotate the filter towards the outlet
section to complete the seal.
8. Replace the service cover. Place the service
cover in position and fasten the latches. Note: If
the cover doesn’t seat, remove and recheck the
filter position.
9. Visually inspect the inlet and outlet connections
including the vacuator valve. Replace if any
signs of wear or damage are visible.
5.9: Checking Belt Tensioner Spring Tension
A belt tension gauge will not give an accurate measure of the belt tension
when automatic spring tensioner is used. Measure tensioner spring tension
using a torque wrench and procedure outlined in the engine manual that was
issued with this truck. For full guidelines and instructions on working on
Automatic Fan Belt Tensioner please also refer to engine manual.
5.10: Greasing Mast Channels
All roller surfaces must be greased periodically where the
fork carriage and mast sections run. The frequency of this
operation is at the discretion of the user and essentially
depends upon the working conditions and the workplace.
A lubrication interval of about 250 hours can be taken as a
typical value, under normal working conditions. For this
purpose use graphite grease, avoid spray greases.
5.11: Greasing Mast Carriage Channels
The mast carriage channels must be greased periodically
only on the vertical
(side) surfaces
where the wear pads run. The frequency of this operation is at
the discretion of the user and essentially depends upon the working conditions
and the workplace. A lubrication interval of about 250 hours can be taken as a
typical value, under normal working conditions. For this purpose use EP2
grease.
