InteliNano-NT Plus, SW version 2.0.1.x,
©ComAp – July 2015
6
2
System Overview
General description
2.1
The
InteliNano
NT
Plus
is an
Automatic Mains Fail
or
Manual Remote Start
controller for single
generating sets operating in stand-by mode or as a prime mover. The
InteliNano
NT
supports electronic
engines.
InteliNano
NT
controllers are equipped with an intuitive graphic display, which together with extensive
functionality set the new standard in gen-set controls.
The
InteliNano
NT
Plus
can automatically starts the gen-set, opens the MCB and closes the GCB upon
mains failure. When the mains is restored, the controller automatically opens the GCB, closes the
MCB, and stops the engine. This controller can also work as a controller for prime mover systems.
InteliNano
NT
Plus
supports diesel and gasoline engines.
The key features of
InteliNano
NT
are easy installation and intuitive operation. Users may choose
between predefined configurations for typical applications and user-defined configurations for special
applications.
Configurability
2.2
One of the key features of the controller is high level of adaptability to the needs of every particular
application. This customization is accomplished in the configuration.
N
OTE
:
Use
NanoEdit
PC software to the read configuration from the controller or disk, view it, modify it, and
write the configuration to the controller or disk.
The firmware contains large number of binary inputs and outputs for all available. Configuration will
be determined by application and hardware constraints. One of main tasks of the configuration is
mapping of "logical" firmware inputs and outputs to the "physical" hardware input and output terminals.
A complete configuration consists of the following:
(functions) to physical binary input terminals
(functions) to physical binary output terminals
3. Assigning sensor characteristics
4. Selecting of ECU type if an ECU is connected
The controller is delivered with a
default configuration, which should fit most standard
applications
. The default configuration can be changed from controller’s front panel or by using
NanoEdit
PC software. See
NanoEdit
documentation for details.
N
OTE
:
For connection with PC use integrated USB module. The controller can be powered directly from USB
communication port. In this case the LCD backlight is turned off and all outputs are open
Once the configuration is modified (using PC) it can be stored in a file for reference or use with
another controller. This configuration file is called the
archive
and has file extension ".ain". If the
archive is saved while the PC is online with the controller, it will contain a full image (setpoints,
measured values, and history log) of the controller at the moment of saving (except firmware).
The archive can then be used for the
cloning
of controllers, which means preparing controllers with
identical configuration and settings.
