InteliDrive Lite, SW version 1.9
ID-FLX-Lite-1.9r1 Reference Guide.pdf,
©ComAp – August 2015
111
Under limit
Protection is activated only when measured value is under measured level.
Over limit
Protection is activated only when measured value is over measured level.
Undfls
Level 2 protection is activated by sensor fail too.
Ovfls
Level 2 protection is activated by sensor fail too.
7.11 SMS/E-Mail
H
INT
If a cellular network modem and/or internet bridge is connected to the controller, the controller can
send SMS messages and/or emails in the moment when a new alarm appears in the Alarm list. The
message will contain a copy of the Alarm list.
To enable this function, you should select with setpoints
Yel Alarm Msg
and
Red Alarm Msg
, which
levels of alarms shall be announced (red/yellow/both) and also enter valid cellular network phone
number and/or e-mail address to the setpoints
TelNo/Addr Ch1
and
TelNo/Addr Ch2
. It is possible to
put either number or e-mail to both setpoints.
N
OTE
:
An internet module must be available for sending of e-mails. Similarly, a cellular network modem is
necessary for sending of SMS.
H
INT
There are 5 attempts for any active call (SMS/E-Mail). Timeout for connection is 90 sec and after 120
sec controller starts the next attempt. During the time the IL-NT-GPRS is trying to send an active call
type, incoming calls are blocked.
7.11.1 Yel Alarm Msg
[OFF, ON]
Set this setpoint to YES if you want to get messages when a
yellow
(warning) alarm occurs.
H
INT
The target address (cellular network phone number or e-mail address) must be set correctly to the
setpoint(s)
TelNo/Addr Ch1
resp.
TelNo/Addr Ch2
.
7.11.2 Red Alarm Msg
[OFF, ON]
Set this setpoint to YES if you want to get messages when a
red
(shutdown) alarm occurs.
H
INT
The target address (cellular network phone number or e-mail address) must be set correctly to the
setpoint(s)
TelNo/Addr Ch1
resp.
TelNo/Addr Ch2
.
7.11.3 TelNo/Addr Ch1, 2
[…]
Enter either a valid cellular network phone number or e-mail address to this setpoint, where the alarm
messages shall be sent. Type of active call is considered from the value of this parameter. If it consist
„@“ it is supposed to be e-mail address and active e-mail is sent. If the value is number, without „@“, it
is supposed to be the telephone number and active SMS is sent.
