5
Get to Know Your STAT
IM
B: Read this Manual
The details of installing, using and maintaining your STAT
IM
B are all in this manual. Please read this manual
before operating the unit and keep it for future reference. Users should follow the operating instructions and
maintenance schedule described in this manual. Contents of this manual are subject to change without
notice to reflect changes and improvements to the STAT
IM
B product.
Water Quality
High quality distilled water is recommended for use in your STAT
IM
B. Deionized, demineralized, or specially
filtered water can also be used as long as the water produced contains less than 5 ppm total dissolved
solids (having a conductivity of less than 10 uS /cm). Never use tap water.
User Qualifications
The operation and maintenance of this unit should be restricted to trained and authorized personnel.
Repair and Modifications
Do not permit any person other than certified personnel to supply parts, service or maintain your STAT
IM
B.
SciCan shall not be liable for incidental, special or consequential damages caused by any maintenance or
services performed on the STAT
IM
B by a third party, or for the use of equipment or parts manufactured by
a third party, including lost profits, any commercial loss, economic loss, or loss arising from personal injury.
Never remove unit panels. Never insert objects through holes or openings in the cabinetry. Doing so may
damage the unit and / or pose a hazard to the operator.
WiFi Compliance
This product complies with the requirements of the following EU Directive: EUROPEAN DIRECTIVE 2014/53/
EU (Radio Equipment Directive). Compliance to this directive implies conformity to harmonized EU standards
that are noted in the EU Declaration of Conformity for the WiFi module.
This device has been tested and found to also comply with the ETSI and Industry Canada limits for a Class
B digital device pursuant to the U.S. Federal Communications Commission’s Part 15 Subpart B. The total
radiated energy from the main antenna connected to the wireless card conforms to the FCC limit of the SAR
(Specific Absorption Rate) requirement regarding 47 CFR Part 2 Section 1093, when the autoclave was
tested. The transmission antenna for the wireless card is located in the front fascia.
Incident Reporting
Any serious incidents should be reported to the manufacturer and/or the competent authority in which the
user and/or patient resides.
Pay close attention to the following symbols that appear on the unit:
Caution:
Refer to manual for details.
MD
Medical Device
Caution:
Hot surface and/or hot steam.
Caution:
Risk of electrical shock.
Disconnect supply before servicing.
Steam distilled water only.
CAUTION!
Follow your local guidelines governing the verification of a sterilisation procedure.
