29
6. Using Your STATCLAVE
6.1 Running a Cycle
Once the autoclave has been correctly installed and before using your STATCLAVE for the first time,
make sure BOTH the clean water reservoir and Venturi reservoir are full. Refer to Section 4. Filling the
Water Reservoirs for detailed instructions.
1.
Power on the unit
The main switch is located below the
door handle.
2.
Ensure both reservoirs are full
You will not be able to start a cycle if
the reservoir levels are below the minimum
fill lines.
3.
Open the door
The LCD should display the UNLOCKED
icon. Pull up on the handle to disengage the
manual latch and open the door. If the door
will not open, press the LOCK icon to go to
the door lock status screen and press the
UNLOCK icon.
4.
Load the instruments
To ensure correct loading, see Section 5.
Loading Instruments.
CAUTION! Hot Chamber.
The unit’s Stand-by mode is preset to maintain a hot chamber. To avoid burns, take
care not to touch the chamber, rack or door with bare hands.
