14
Connecting the Waste Bottle
The unit is shipped with a waste bottle in case a direct-to-drain installation is not possible. To use the
waste bottle, follow these steps:
1.
Set the waste bottle (D) on the ground or in
the cabinetry below the unit.
2.
Connect the exhaust tube (A) to a port on the
waste bottle cap (C).
3.
Connect the reservoir overflow tube (B) to a
port on the waste bottle cap (C).
2.4
Connecting your STATCLAVE to a Network
Connecting to a Wired Network
IMPORTANT!
Tubes should not be kinked,
bent or otherwise obstructed. The connection
point to the central drain must be lower than
the autoclave’s support surface otherwise the
reservoirs may not drain correctly.
IMPORTANT!
Avoid excess sagging in the
lines; cut both tubes to measure.
1.
3.
2.
Add a small amount of water to the empty
waste bottle to give it stability.
