ColorKey CKW02-C192, User Manual

Page: 24 / 26

a 120 resistor between Signal (-) and Signal (+) into a 3-pin XLR-plug and plug it in
the DMX-output of the last fixture.
In the Controller mode, at the last fixture in the chain, the DMX output has to be connected
with a DMX terminator. This prevents electrical noise from disturbing and corrupting the
DMX control signals. The DMX terminator is simply an XLR connector with a 120W
(ohm) resistor connected across pins 2 and 3, which is then plugged into the output socket
on the last projector in the chain. The connections are illustrated below.
120 ohm
PIN 2
PIN3
If you wish to connect DMX-controllers with other XLR-outputs, you need to use adapter
cables.The transform of the controller line of 3 pins and 5 pins (plug and socket)
USER MANUAL
19/21
DMX 512 CONTROLLER SERIES
4.3 DMX Dipswitch Quick Reference Chart
DMX Address Quick Reference Chart
Dip Switch Position
DMX DIP
SWITCH SET
O=FF 1=ON
X=OFF or ON
#9 0 0 0 0 0 0 0 0 1 1 1 1 1 1 1 1
#8 0 0 0 0 1 1 1 1 0 0 0 0 1 1 1 1
#7 0 0 1 1 0 0 1 1 0 0 1 1 0 0 1 1
#6 0 1 0 1 0 1 0 1 0 1 0 1 0 1 0 1