ColorKey CKW02-C192, User Manual

Page: 14 / 26

USER MANUAL 10/21
DMX 512 CONTROLLER SERIES
6) Select a SCENES button to store. All LED blinks once data are saved.
7) Repeat steps 2 through 6 as need. 8 scenes can be recorded in a Program
8) Press the
PROGRAM button until the LED OFF to quite program mode.
3.3.3 RUNNING A CHASE
Action :
1) Press AUTO/DEL to enter auto running
mode and AUTO indicated led ON.
2) Press target run CHASE number button
and tap the TAPSYNC DISPLAY button
twice to run it. Multi chases could be
selected at the same time to run in cycle.
3) Use BANK UP/DOWN buttons to
change Program banks if there is no
chase.
4) Adjust the PROGRAM speed via the
SPEED fader and the loop rate via the
FADE TIME fader. The time between
two taps sets the time between SCENES
(up to 10 minutes).
Notes :
Deselect Blackout if LED is lit.
Also called a Tap-Sync.
3.3.4 CHECK A BANK
Action :
1) Press and hold the PROGRAM button
until the LED blinks.
2) Use the BANK UP/DOWN buttons
to select the PROGRAM bank to
review.
3) Press the SCENES buttons to
review each scene individually.
3.3.5 EDITING A PROGRAM
Scenes will need to be modified manually.
Action :
1) Press and hold the PROGRAM button
until the LED blinks.
2) Use BANK UP/DOWN buttons to change
Program banks if need.
3) Select the targeted fixture via the
SCANNERS button .
4) Adjust and change fixture attributes using
the channel faders and wheel.
5) Press the MIDI/ADD button to prepare
the save.
6)Select the desired SCENES button to
save.
3.3.6 COPY A BANK
Action :
1) Press and hold the PROGRAM button
until the LED blinks.
2) Use BANK UP/DOWN buttons to select
the PROGRAM bank you will copy.
3) Press the MIDI/ADD button to prepare
the copy.
Notes :
Notes :
Deselect Blackout if LED is lit.
Notes :
All 8 scenes in a Program
Bank will be copied.
the copy .