COBHAM explorer 727, User Manual

Page: 61 / 179

Chapter 4: To use the web interface
98-126882-F To use the Dashboard 54
• Status . The status of the EXPLORER 727 System.
The status can be one of the following:
•
Scanning. The terminal has instructed the antenna to scan for a BGAN signal. (The
antenna status will show “Sky scan”)
•
Searching
. The antenna has found a BGAN signal and the terminal is searching for a
BGAN network in order to perform a registration. (The antenna status will show
“Tracking”)
•
Registering
. The terminal is trying to register with the Satellite Access Station (SAS).
•
Ready
. The terminal has registered and connected to the SAS and is ready to accept a
service request (a call or a data session).
•
Data active
. The terminal has established a call or a data session through the BGAN
network.
•
No position fix
. The GNSS receiver has not yet achieved position fix. It may take some
time to achieve position fix depending on a number of conditions. First of all, the
antenna should have an unblocked view to as much of the sky as possible.
The terminal will not be able to register with the SAS without a position fix.
•
Not registered
. The terminal has not been able to register with the BGAN network.
•
Satellite selection
. The satellite selected for logon. For further information, see To select
the preferred BGAN satellite on page 107.
•
Current satellite
. The satellite to which the system is currently logged on.
• Unit serial number . The serial number of the terminal.
•
Software version
. The version of the software embedded in the terminal.
•
Local IP address
. The local IP address of the terminal. This is the IP address used to
access the terminal from a device connected to the terminal.
•
IMEI number
. The IMEI number (International Mobile Equipment Identity) of the
terminal. This is a unique number that identifies your terminal.
• Antenna status . The status of the antenna.
The antenna status can be:
•
Sky scan . The antenna is searching for the BGAN signal.
•
Tracking
. The antenna has found and locked to the BGAN signal. The antenna is now
tracking the BGAN signal.
•
No antenna
. No known antenna is detected by the terminal.
•
Terminal usage mode
.
The usage mode of the terminal can be:
•
Standard (on-the-move)
. The terminal works as a normal EXPLORER 727.
•
X-Stream (on the pause)
. Apart from the normal EXPLORER 727 functionality, the
terminal supports BGAN X-Stream and extended coverage for 256 kbps Streaming and
ISDN.
This mode is only available when the terminal is stationary (not moving)
.