COBHAM explorer 727, User Manual

Page: 164 / 179

Chapter 5: Maintenance and troubleshooting
98-126882-F Supported AT commands for PPPoE 157
• <destination port range> is Destination Port From.To (0.0-65535.65535)
• <source port range> is Source Port From.To (0.0-65535.65535)
Example:
AT+CGTFT=1,1,0,87.48.134.251.255.255.255.0,6,20.21,1024.65535
AT+CGDSCONT
Usage:
AT+CGDSCONT is used to specify the Secondary Contexts relation to a Primary Context. The
Secondary Context’s cid must be different from the Primary Context’s cid. The Secondary
Context’s QoS must be set using the AT+CGEQREQ command explained above.
Syntax:
AT+CGDSCONT=<cid>,<p_cid>
• <cid> is the cid for the Secondary Context
• <p_cid> is the Primary Context at which the Secondary is related to.
Example:
AT+CGDSCONT=1,11
Application example
This example shows the commands needed in order to establish a Primary Standard Data
Context with a Secondary Streaming 256K Context where all UDP traffic goes through the
Streaming 256K Data connection and all other traffic goes through the Standard Data
connection.
• AT+CGDCONT=1,ip,bgan.inmarsat.com
(Specifies the APN)
• AT+CGEQREQ=1,3
(Sets cid 1 = Standard data)
• AT+CGTFT=11,1,0,,17
(Sets UDP TFT filter for cid 11)
• AT+CGEQREQ=11,1,256,256,256,256
(Sets cid 11 = Streaming 256K QoS)
• AT+CGEQMIN=11,1,256,256,256,256
(Specifies min. acceptable QoS to Streaming 256K)
• AT+CGDSCONT=11,1
(Defines Secondary cid 11 on Primary cid 1)
If you have any technical questions about the PPPoE feature please refer to your local
distributor, who can assist you with the configuration.