BODY AND TRIM
Dash Assembly
2004 Precedent IQ System Golf Car Maintenance and Service Manual
Page 4-15
4
DASH ASSEMBLY INSTALLATION
1. Position dash assembly (1) on vehicle. Make sure tabs on the forward edge engage to front underbody.
Secure assembly in place with three screws (2)
(Figure 4-8, Page 4-14)
. Tighten screws to 8.8 ft-lb (12
N·m).
2. Position dash tray (6) in dash and secure with two barrel fasteners (7).
3. Install the instrument panel.
3.1. Connect the electrical connector on the instrument panel to the harness connector.
3.2. Position the instrument panel (3) on the dash assembly. Make sure tabs on upper edge properly
engage with the corresponding slots on the dash assembly. Ensure that there are no wires exposed
or pinched during positioning.
3.3. Secure instrument panel to the dash assembly with screws (4 and 5). Tighten screws to 1.8 ft-lb (2.5
N·m).