MOTOR
Motor Speed Sensor
2004 Precedent IQ System Golf Car Maintenance and Service Manual
Page 15-15
15
MOTOR SPEED SENSOR
See General Warnings, Section 1, Page 1-1.
Testing the Motor Speed Sensor
See Test Procedure 13, Section 11, Page 11-38.
Motor Speed Sensor Removal
1. Disconnect the battery cables as instructed.
See WARNING "To avoid unintentionally starting..." in
General Warnings, Section 1, Page 1-2.
2. Disconnect the three-pin connector (22) from the vehicle wire harness
(Figure 15-20, Page 15-16)
.
3. Using a screwdriver, gently pry the motor speed sensor (21) from recessed area on the motor end shield.
Motor Speed Sensor Installation
1. Position the motor speed sensor (21) as shown and firmly press the speed sensor into the motor end
shield. Sensor should fit flush against the motor
(Figure 15-20, Page 15-16)
.
2. Connect the three-pin connector (22) to the vehicle wire harness.
3. Place the Tow/Run switch in the TOW position and connect the batteries, positive (+) cable first. Tighten
battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector Spray (CCI
P/N 1014305) to minimize corrosion.
Figure 15-18 Motor Installation
Figure 15-19 Motor Mount
24
25
VIEWED
FROM
DRIVER
SIDE
4
2
3
1