ELECTRICAL COMPONENTS
Battery Warning Light
Page 12-4
2004 Precedent IQ System Golf Car Maintenance and Service Manual
12
FORWARD/REVERSE ROCKER SWITCH
See General Warnings, Section 1, Page 1-1.
Testing the Forward/Reverse Rocker Switch
See Test Procedure 15, Section 11, Page 11-40.
Forward/Reverse Rocker Switch Removal
1. Disconnect the battery cables as instructed.
See WARNING "To avoid unintentionally starting..." in
General Warnings, Section 1, Page 1-2.
2. Remove two screws (2) that hold Forward/Reverse rocker switch housing (1) to the vehicle
(Figure 12-4,
Page 12-4)
.
3. Remove the three wires from the rocker switch.
4. Press in on the locking tabs on each side of switch (3), and push switch out of housing.
Forward/Reverse Rocker Switch Installation
1. Route the three wires through bezel. Connect the three wires to the rocker switch (3), exactly as shown
in
(Figure 12-4, Page 12-4)
.
2. Orient the rocker switch (3) so the terminals are towards the front of the housing (1). Push rocker switch
(3) into housing (1)
(Figure 12-4, Page 12-4)
.
3. Place the housing in position on the body and install the two screws (2). Tighten to 20 in-lb (2.3 N·m).
4. Place the Tow/Run switch in the TOW position and connect the battery cables, positive (+) cable first.
Tighten battery terminals to 110 in-lb (12.4 N·m) and coat terminals with Battery Terminal Protector
Spray (CCI P/N 1014305) to minimize corrosion.
5. Place the Tow/Run switch in the RUN position.
6. Inspect the vehicle for proper operation.
Figure 12-4 Forward/Reverse Rocker Switch
2
2
1
3
BLUE
RED
WHITE
