BODY AND TRIM
Rear Body
2004 Precedent IQ System Golf Car Maintenance and Service Manual
Page 4-11
4
REAR BODY COMPONENTS REMOVAL
Rear Beauty Panel Removal
1. Remove SAM.
See SAM Removal on page 4-9.
2. Remove one screw (3) from each canopy support bracket (1 and 2)
(Figure 4-7, Page 4-13)
. Remove
canopy supports.
3. Remove four screws (13) attaching the rear beauty panel (12) to the fuel bucket.
4. Remove two screws (14) and remove housing (15) from vehicle.
5. Disconnect electrical wires from switch (16).
6. Lift rear beauty panel from vehicle.
Rear Beauty Panel Installation
1. Install rear beauty panel (12) on vehicle. Make sure body clips on the rear of the beauty panel engage
the mating slot in the rear underbody. Secure beauty panel in place with four screws (13). Tighten screws
to 3.7 ft-lb (5 N·m).
2. Connect the three wires to the switch (16) in the order shown.
3. Position the housing (15) on the front of beauty panel (12) and secure with two screws (14). Tighten
screws to 20 in-lb (2.3 N·m).
4. Position canopy support brackets (1 and 2) on vehicle and secure each with one screw (3). Tighten
screws to 6.6 ft-lb (9 N·m).
5. Position the SAM on the vehicle.
See SAM Installation on page 4-9.
Access Panel
Access panel (6) is secured to the rear underbody (4) with two expanding screws (7)
(Figure 4-7, Page 4-13)
.
When replacing the panel, tighten screws (7) enough to hold the panel in place.
Rear Underbody Removal
1. Remove four screws (5) attaching the rear underbody (4) to vehicle
(Figure 4-7, Page 4-13)
.
2. Remove two screws (18) that attach the underbody to the two liners (8 and 9).
3. Lift the rear edge of the rear underbody (4) until the front portion slides out from beneath the front under-
body. Remove the rear underbody from the vehicle.