Club Car Carryall XRT 1550, Maintenance And Service Manual

Page: 50 / 432

4
Seat Belts BODY AND TRIM
SEAT INSTALLATION
1. Align the hinges on the underside of the seat front edge with the hinge slots on the frame.
2. Bucket seats
2.1. Push back and down on the seat back to secure the seat latch to the frame. See preceding WARNING.
3. Bench seat
3.1. Hold center seatbelt buckles (if equipped) up and out of the way. Lower rear of seat to frame.
SEAT SUPPORT REMOVAL
1. Remove the bolts (9), washers (10 and 11), and flanged locknuts (12) from the seat support (7) and engine cover
plate
(Figure 4-1, Page 4-7) .
2. Remove the seat support.
SEAT SUPPORT INSTALLATION
1. Install the seat support (7) (Figure 4-1, Page 4-7) .
2. Secure the seat support to the seat side plates with bolts (9), washers (10 and 11), and flanged locknuts (12).
Tighten the hardware to 37 ft-lb (50 N·m).
SEAT BELTS
See General Warnings, Section 1, Page 1-2.
CAUTION
• Be careful not to damage the safety belt webbing or hardware.
• Inspect the safety belt system periodically. Check for cuts, fraying, and loose parts. Replace damaged
parts immediately. Do not disassemble or modify the system.
• Keep safety belts clean and dry. If cleaning is necessary, use a solution of mild soap and lukewarm
water. Do not use bleach, dye, or abrasive cleaners as they may severely weaken the safety belts.
• Do not insert coins, clips, etc. into the safety belt buckle. Foreign objects may interfere with the
buckle locking mechanism.
• If the safety belt does not function normally, contact your dealer/distributor or trained technician
immediately. Do not occupy the seat until the safety belt is repaired.
BENCH SEAT BELT REMOVAL
1. Remove the flange bolt and nut from the base of the coiled seat belt assembly (outside location) (Figure 4-2,
Page 4-11) .
Page 4-10 2013 Carryall 295/XRT 1550 Maintenance and Service Manual